Tin Whiskers: Concerns & Potential Impact


Reading time ( words)

What is the biggest concern about the growth of tin whiskers? A simple answer is “uncertainty.”

Electronic system failures attributing to or related to whiskers have been reported in the past before the electronics industry was converted to lead free. With the elimination of the use of lead (Pb) in electronics in compliance with worldwide RoHS regulations, Pb-free materials including pure tin (Sn) have been used as surface coating for component leads and metal terminals, and as solder materials in making solder joints.

Pure tin makes a practical replacement to Sn-Pb as a choice of surface coating because of its economics, availability, and performance in manufacturability, compatibility, and solderability. Today, most component manufacturers offer pure tin-coated components.

On electronic system failure, as an illustration, one of the well-studied and highly publicized incidents was the TOYOTA Camry 2003 model investigation. The unintended acceleration of the vehicle speed control was reported in 2009. National Highway Traffic Safety Administration (NHTSA) initiated an investigation with the technical support of NASA Engineering and Safety Center. Destructive physical analysis of a failed accelerator pedal position sensor assembly from a consumer vehicle that was identified with a diagnostic trouble code found the presence of tin whiskers. A tin whisker had formed a 248 Ω resistive short between two terminals of the accelerator pedal position sensor of its potentiometer accelerator pedal assembly. A second tin whisker of similar length grew from a 5-volt source terminal adjacent to a pedal signal output terminal, but this whisker did not make contact with any other terminals at the time of the analysis.

Read the full column here.


Editor's Note: This column originally appeared in the November 2013 issue of SMT Magazine.

Share




Suggested Items

VJ Electronix: Automating the X-ray Inspection Process

05/04/2022 | Nolan Johnson, I-Connect007
VJ Electronix's Brennan Caissie shares the benefits of a new inspection tool that can be used on a variety of boards, with an automated system that takes the pressure off the manufacturing floor operators and can provide feedback all the way to the design process.

Dave Hillman on Living Your Passion

03/29/2022 | Barry Matties, I-Connect007
Barry Matties leads this engaging retrospective conversation with Dave Hillman, a Fellow, Materials and Process engineer at Collins Aerospace, who talks about mentorship, pandemic changes, and solder. “Soldering is soldering,” Dave says. “But how we do that keeps evolving in response to the new technologies and smaller packages.” What’s the key to his success and longevity? “Find your passion.” Here’s how he’s done it.

IPC’s Dieter Bergman Fellowship Award Presented to Bev Christian, HDPUG

03/14/2022 | Patty Goldman, I-Connect007
The Dieter Bergman IPC Fellowship Award is given to individuals who have fostered a collaborative spirit, made significant contributions to standards development, and have consistently demonstrated a commitment to global standardization efforts and the electronics industry. Bev Christian is a facilitator for the High Density Packaging User Group (HDPUG) and an adjunct associate professor in the Department of Mechanical and Mechatronics Engineering of the University of Waterloo, Waterloo, Ontario, Canada. In the past 31 years he has held positions at Nortel, BlackBerry, and CALCE; all in the areas of materials and failure analysis. Bev has never missed an IPC APEX EXPO since its inception. He is a member of 27 IPC committees and attends as time and the lack of clones allow.



Copyright © 2022 I-Connect007. All rights reserved.