Benefits of Soldering with Vacuum Profiles


Reading time ( words)

Requirements for void-free solder joints are continuously increasing in the field of electronics manufacturing (i.e., the reduction or elimination of cavities in the connection technology used between component connectors and connector pads). New challenges evolve on a daily basis due to the relentless introduction of new variants of so-called bottom-terminated components (BTCs), some of which are shown in Figure 1. Connector geometries alone are not decisive—numerous pitfalls are of greater significance. Incentives and several fundamentals will be elucidated in the following article.

Rehm-fig-1.jpg

The formation of solder joints is PCB manufacturing, and thus their quality, is influenced by an unmanageably large number of parameters, which are becoming increasingly difficult to master and control. A voids workgroup prepared the overview of factors shown in Figure 2, which provides an initial insight into the complexity of the problem. However, it only includes two factors that can be taken advantage of shortly before production of the affected PCBs in order to reduce or eliminate the formation of voids. These are the stencil and the layout of the aperture on the one hand, and the use of vacuum technology during the soldering process itself on the other hand. Vacuum soldering can even be used during the production processes as a sort of fire brigade when a short-term increase in the number of voids occurs. Thus, nothing stands in the way of using standard processes and standard profiles for series production; it’s possible to react flexibly to any fluctuation in the quality of purchased components, PCB surfaces and solder paste batches.

In addition to series production, PCBs can also be repaired in modern vacuum soldering systems like the CondensoX, in the event that excessively large voids have occurred during the initial soldering process in a conventional soldering system, which would otherwise have to be scrapped because they do not fulfill the criteria of the applicable IEC standards or IPC directives.

Rehm-fig-2.jpg

Vacuum is defined as follows in DIN 28400 (in agreement with ISO 3529-1):

“Vacuum is the state of a gas when the pressure of the gas, and thus the particle-number density, is lower within than it is outside of its container, or when the pressure of the gas is less than 300 mbar (i.e., lower than the smallest atmospheric pressure which occurs on the surface of the Earth.”)

Share




Suggested Items

Automation and Flexibility: Essential Components for Future-thinking EMS Companies

03/29/2023 | Norihiro Koike, Saki Corporation
The near future for electronics manufacturing services is all about automation and flexibility. Three key factors affect EMS companies today: the high cost of labor, maintaining a reliable supply chain, and an increasingly high variety of products being manufactured. Quality trained personnel are essential and the supply of both product components and machine parts must remain stable despite difficult geopolitical situation.

Real Time with... IPC APEX EXPO 2023: Automotive Electrification

02/08/2023 | Real Time with...IPC APEX EXPO
Nolan Johnson talks with Senior Product Manager Chris Nash of Indium Corporation, who discusses Durafuse LT, a novel solder paste mixed alloy system with highly versatile characteristics that enable energy savings, high-reliability, low-temperature, step soldering, and assemblies with large temperature gradients. It also provides superior drop shock performance to conventional low-temperature solders, outclassing BiSn or BiSnAg alloys, and performing better than SAC305 with optimum process setup.

Real Time with … IPC APEX EXPO 2023: Mycronic Extends Reach

01/11/2023 | Nolan Johnson, I-Connect007
Clemens Jargon, senior vice president of High Flex at Mycronic, shares his thoughts about the company’s performance in 2022 (it was a strong year), plans for the new year (turnkey solutions), and what visitors to the Mycronic booth at the show can expect to see in the company’s state-of-the-art Iris™ 3D AOI vision technology.



Copyright © 2023 I-Connect007 | IPC Publishing Group Inc. All rights reserved.